Increases Speed
MegaScreed sets in seconds. One person can accurately set screed locations in a fraction of the time it takes with other methods.

Give a Better Finish
A faster and flatter laydown means a better finish with MegaScreed. Eliminates pockets caused by stake removal and low spots from wet screeding.

Improves Accuracy
MegaScreed gives SUPERFLAT results. SUPERFLAT = FF100/FL50
Results are better than the ASTM standard of 1/8" deviation in 10'.

Custom Orders
MegaScreed orders can be customized for #4 and/or #5 rebar and are available in a wide variety of quantities for your convenience.

MegaScreed® Concrete Leveling System
Saves you TIME...and TIME is MONEY!

 

 

 


Determine the finished elevation of concrete with a laser or string line and position a #4 or #5 rebar stake on the subgrade at the strikeoff point. Place the MegaScreed Driver over the rebar and strike with a Dead Blow Hammer until the height marker aligns with the laser or string line.

Remove the Driver and place the high strength Yoke over the rebar. The Yoke will maintain the exact position indicated by the height marker. Repeat this procedure as necessary at each screed location. Then set a 1-1/2"ID, 2" OD screed pipe on top of Yokes and you are ready to pour.


MegaScreed Specially designed for large concrete finishing operations and heavy-duty industrial finishing equipment. MegaScreed is up to several times faster than conventional methods and offers extraordinary convenience and economy.


MegaScreed Kit

 Our MegaScreed Kit includes 1 driver, 200 yokes, and 1 bag.

MegaScreed 500Kit
Our MegaScreed 500 Kit includes 1 driver, 500 yokes, and 1 bag.


Copyright© 1998-2001 Landre Company

AccuScreed® and MegaScreed® are the property of Landre Corporation. They may not be used without written permission prior to their use.

This site is best viewed with IE or Netscape 4.0 or higher at 800 X 600, with JavaScript, frames, and FLASH enabled on your browser.